1. Engineering
  2. Mechanical Engineering
  3. 7 this problem relates to tolerance stackup using the absolute...

Question: 7 this problem relates to tolerance stackup using the absolute...

Question details

7. This problem relates to tolerance stack-up using the absolute tolerance system, as explained in section 1-14. In the figure below, specified dimensions are as follows (all units in inches): 1.750 ± 0.001 3.200 ± 0.005 | ? ± 0.010 2.000 ± 0.003 2 0 (a) If the gap, w, must be at least 0.015 in for the proper functioning of the assembly, what is the correct nominal dimension for d?

Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution