Zookal Homework Help

Homework Help

  1. Engineering
  2. Mechanical Engineering
  3. can someone design this with screenshots from creo 40...

Question: can someone design this with screenshots from creo 40...

Question details

109 Extrusions Problems 1.9 Design frame_guide (Figure 4-94) with the origin located on the centerline of the 1.500-inch diameter through hole directly below the center of the 0.19-inch diameter hole. The two through holes need to be 1.69 inches from the centerline of the large hole. All dimensions are in inches. Design change: increase the 0.19-inch diameter hole to 0.25 inches. 4.19 2x R25 R1.19 .44 .44 1.50 FILLETS R.06 2.00 1.88 Figure 4-94 Problem 9 Can someone design this with screenshots from creo 4.0
Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution