1. Engineering
  2. Mechanical Engineering
  3. design modification the part shown is to be modified so...

Question: design modification the part shown is to be modified so...

Question details

Design modification: the part shown is to be modified so that the 1.0inch diameter hole is changed into a slot with semicircular ends of radius 0.5 inches. One center is to remain at the current location of the hole and the center of the other semicircular end is 1.5 inches toward the notch. The rectangular notch is changed to a semi- cylindrical slot with a radius of 0.75 inches. Draw the three views of the revised design. Draw the views scale 1:1. .7 50 75 1.00 1.00 Φ1.0 2.00 3.50 R1.50 1.00
Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution