1. Engineering
  2. Mechanical Engineering
  3. help please...

Question: help please...

Question details
Help please

RCES Problem 1.030 Pressurized water (pin 10 bar, T 110°C enters the bottom of an L 10-m-long vertical tube of diameter D-88 mm at a mass now rate of 1.75 kg/s The tube is located inside a combustion chamber, resulting in heat transfer to the tube. Superheated steam exits the top of the tube at par , 7 bar, Tor 60 Determine the change in the rate at which the following quantities enter and exit the tube: (1) the combined thermal and flow work, (2) the mechanical energy, and (3) the total energy of the water. Also, (4) determine the heat transfer rate, q. Hint: Relevant properties may be obtained from a thermodynamics text. Step 1 What is the outlet specific volume, in m3/kg? the tolerance is +/-5% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: 0 of 3 used save POR LATER - Step 2 What is the outlet velocity, in m/s? mys the tolerance is +/-5%
Step 3 What is the change in specific enthalpy from inlet to outlet, in k/kg? kJ/kg the tolerance is +/-596 By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: o of 3 used SAVE FOR LATER SUBMIT ANSWER Step4 Solve for the rate of change in the combined thermal and flow work energy from inlet to outlet, in MW Mw the tolerance is +/-5% By accessing this Question Assistance, you will learn while yot earn points based on the Point Potential Policy set by your instructor Attempts: o of 3 used SAVE FOR LATER SUBHIT ANSWER
▼ Steps Solve for the rate of change in mechanical energy from inlet to outlet, in MW MW the tolerance is +/-5% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: o of 3 used SAVE rOR LATER SUBMIT ANSWER SUBMIT ANSWER Step What is the total heat transfer rate from the pipe, in MW? the tolerance is +/-5% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: 0 of 3 used sAVE FOR LATESUBAIT ANSWER
Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution