1. Engineering
  2. Mechanical Engineering
  3. kse 2018 dimensioning practices engineering graphies with solidw questions r...

Question: kse 2018 dimensioning practices engineering graphies with solidw questions r...

Question details

KSE 2018 Dimensioning Practices Engineering Graphies with SOLIDW Questions r the same information the size value is placed within given i 1. True or False: D imensions should not be duplicated o ed, two different ways. If a reference dimension parentheses () is used, t unit system is also known as the (IPS) unit syste n as the (IPS) unit system. What does IPS sta for? S. The diameter of a hole is placed in the view in which th 4. The length and is shown as a . diameter of cylinder are usually placed in the view which shows the cylinder as a 5. Dimension a hole by its 6. True or False: 7. If hid imensioning to hidden lines should be avoided wherever possible. a hole goes completely through the feature and it is not clearly sh drawing, the abbreviation own on the follows the dimension. rue or False: A dimension is said to have a Umilateral (single) tolerance when the total tolerance is in one direction only, either (+) or ). 8. T 9. The degree () may be divided into smaller units called There are 60 in each degree. Each minute may be divided into smaller units called 10. Classes for an External (male thread) have aS 11. Classes for an Internal (female thread) have a 12. There are three major Thread classes of fits; they are: suffix suffix. . Explain the differences. 13. Identify the pitch of the following Thread note: 3/8-16 UNC 2B DOUBLE 14. Identify the symbol of a Counterbore and Countersunk: PAGE 3-46

Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution