# Question: often you need to make an estimate of the forces...

###### Question details

Often you need to make an estimate of the forces where you would not have time or tools to perform a detailed analysis. In this module, we will discuss methods for estimating loads or other statics results on rigid bodies. The Free Body Diagram is a good tool for estimation as you can visually add forces and moments. You can round given force values to one or 2 places of precision. You can also approximate centroids and centers of gravity by visual integration of the largest areas. For 2nd Moment of area and moment of inertia adjust for things further from the axis having more weight.

**An example is below:**

For the beam loaded and supported as shown approximate the reactions at A and B.

The 50 N load is close to support A so add 50 the reaction at A.

The 100 N load is about the middle of the beam so add 50 to both reactions.

The 150 N load is above support B so all of it gets transferred to B.

Reaction at A is approximately 100 N and reaction at B is approximately 200 N.

The reaction at A will be slightly greater and the reaction at B will be slightly less than the estimates.

Note that estimation is more of an art than a science so there is not a set procedure. Just apply logic and what you know about statics.

**Assignment:**

**There are two problems listed
below. Approximate, the solutions for both problems and
describe how you approximated the solutions. An
approximation is usually only one or two digits in accuracy. You
are not to completely solve the problem. THESE SHOULD BE
EDUCATED APPROXIMATIONS NOT SIMPLE ANSWERS WITHOUT
EXPLANATION.**

****