Question: q4 a hanger is made from astm a36 structural steel...

Question details

Q4. A hanger is made from ASTM A36 structural steel bar with a square cross section, 10 mm on a side, as shown in Figure P3-81. The radius of curvature is 150 mm to the inside surface of the bar. Determine the load F that would cause yielding of the steel. Use the curved beam formula r= 150 mm 10 mm 10 mm Section A-A 325 mm

Solution by an expert tutor

Question: q4 a hanger is made from astm a36 structural steel...

Question details

Solution by an expert tutor

This question has been solved

Subscribe to see this solution