1. Engineering
  2. Electrical Engineering
  3. rs in ohms rl in ohms ilmax in amps ilmin...

Question: rs in ohms rl in ohms ilmax in amps ilmin...

Question details

1) The resistances of commercially-available discrete resistors are restricted to particular sets. For example, the available values of resistors with 10% tolerance are selections from the E12 set multiplied by a power of ten from 100 through 10s. The E12 set is: E12-10,12, 15, 18,22,27,33,39,47,56,68, 82) Thus, you can buy 10% resistors with a nominal resistance of 3300 or 33M. but not 350n. Furthermore, the tolerance a 10% 390 resistor you can be sure that its resistance is between 351 and 429 means that if you buy In this problem we need to choose 10% resistors to make a current divider that meets a given specification. We are given an input current 1-100μΑ and a linear resistive load represented by the resistor RL-Our resistive load is not regulated for the high current provided by our current source, so we add a resistor RS in parallel to divide the current such that! 0μΑ An additonal requirement is that the Thevenin resistance as seen from the load terminals (with both Rs and R1 connected) is between 60M2 and 80M2. Assume first that the resistors have their nominal resistance. Come up with resistors RS and R1 such that the divider ratio h n İ.s it in 10% of the requirement, where l4arn is the load current using the nominal resistance values. Of course, the resistances you chose are just nominal. Given that they are only guaranteed to have resistances within 10% of the nominal value. what is the largest and smallest value that It may have?

Rs (in Ohms):

RL (in Ohms):

ILmax (in Amps):

ILmin (in Amps):

Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution