1. Engineering
  2. Electrical Engineering
  3. thats all data given what other information do you need...

Question: thats all data given what other information do you need...

Question details

5. Figure 7 shows your first VisSim. programmed into the gain and constant blocks of your program. The slider range is from 0 to 100. Record these results in your Data Sheet. program. Determine the gain and offset that should be programmed iows your first Vissim program

In this exercise you will use VisSim and the NI USB-6008/9 DAQ to produce a variable 0.8V to 4.0V output signal. Your first VisSim programming task will be to build the program shown in Figure 7. Note that the slider output is variable p which is of range. summing junction slider NI DAQmx Analog Out (NI USB-6008 channel AO 0) gain 50 ch0 Analog Dev1 Voltage constant (offset) % of range 2.4 display Figure 7. A variable 0.8 to 4.0V supply voltage. The slider should be configured to range from 0 to 100. The display block should show the supply voltage output (that is, the DAQ output) The supply voltage should range linearly from 0.8 to 4.0V as the slider ranges from 0 to 100. Determining the values for the gain and constant blocks is part of your pre-lab assignment. The first task is to locate the blocks and connect them as shown in Figure 7. There are 3 different ways to find the block you are looking for: » toolbar icons Blocks pull down menu Block tree in left margin *

That's all data given. What other information do you need?

Solution by an expert tutor
Blurred Solution
This question has been solved
Subscribe to see this solution