Question: write a c program that processes every command line argument...
Write a C++ program that processes every command line argument, excluding the program name.
Your program may operate in several modes:
● “Reverse” mode: when enabled, the program reverses the order of the letters in an argument
● “Upper” mode: when enabled, the program converts all lowercase letters in the argument to uppercase letters
● “NoVowel” mode: when enabled, the program skips vowels (a, e, i, o, u, A, E, I, O, U) The program starts with all modes disabled.
As each argument is processed, the program determines the length of each argument. Based on the length, it may toggle the mode settings (“toggle” means if the mode is disabled, enable it, and if the mode is enabled, disable it).
Toggling is performed according to the following rules:
If the length of the argument is evenly divisible by 2, toggle “Reverse” mode
If the length of the argument is evenly divisible by 3, toggle “Upper” mode
If the length of the argument is evenly divisible by 5, toggle “NoVowel” mode ok
After determining the length of an argument and processing any mode toggling, the program must apply any enabled modes to the argument, print the argument out on a line by itself, then proceed to the next argument.
Note that it is possible, and valid, for there to be no command line arguments after the program name.
$ ./prog0 Hello, nothing world bye world ok ,
OLLEH //The first argument is of length 6, which toggles both
Reverse and Upper to on
GNIHTON //The second argument is of length 7, nothing changes
DLRW //The third argument is of length 5, which toggles NoVowel to on
yb //The fourth argument is of length 3, which toggles Upper off
dlrow //The fifth argument is of length 5, which toggles NoVowel to off
ok //The sixth argument is of length 2, which toggles Reverse to off